SliXprings Lever Spring

Tired of wearing the cams off of the finger and carrier levers in your competition rifle?

Tired of having to continually re-arch and/or reset the load on your replacement lever springs?

Want a smoother, more solid feeling, and improved action for your edge in competition?

The Cowboy Action Shooters from TK4B Enterprises have completely redesigned and engineered set of SliXprings to provide a smoother, trouble free competitive replacement lever spring kit. 

These .076” lever springs are made from 100% music wire alloy and have been tested and determined to significantly reduce wear on the cam surfaces of both the finger lever and the carrier lever. The .076” wire size more closely reflects the wear surface diameter of the original springs (both clone and original) and therefore is more tolerant of any wear or pitch variations from manufacturing tolerances. The larger radius at the “Tab” also adds significantly to a smoother and more durable operation. 

In addition, the .076” wire is approximately 3-1/2 times less likely to fatigue or lose its “set” over time. This spring material has been tested to over 900,000 equivalent lever cycles without any lose of tension. However, should either “set” or natural fatigue occur, the spring kit design allows for easy adjustment to return the action to its best operating pressures. The Kit is also designed for the installer to not only easily fit it, but also to be able to very finely tune the carrier spring pressure to adjust for different caliber and bullet weights to guarantee the smoothest uninterrupted action. Likewise the finger lever side can also be finely adjusted to allow for any lever modifications or the added weight of a protective wrap. 

Each Kit contains a complete spring set and both screws and a set of instructions for the more capable home tuner.

Installation Instructions