32 Caliber 100 Grain RNFP Polymer Qty 1000

Excellent service and quality products.

I like these bullets as they allow me to load them hotter without worrying about lead buildup. They also group pretty well. Also on the plus side, if you have any questions or need to contact Badman Bullets, they respond to questions in a very timely manner. 5 stars from me.

EZ reloading, Clean shooting , just like the other calibers I use
PLUS GREAT Customer service

Bullets are great. Poly coating is cleaner on hands and loading equipment. Shipping is free and fast!

I had contacted Badman Bullets about using their .32 100 grain coated bullets in my 327 revolvers at some very high muzzle velocities. The owner asked about the powders I was considering and sent me some recommended loads for MV's between 1200 fps and 1350 fps.

After comparing the results from 3 different powders I ended up selecting 5.4 grains of W231 powder to use with an OAL of 1.470".

I'm able to shoot 1" groups at the short ranges used in personnel defense practice using iron sights. Considering I'm 73 with very poor eyesight, I found this to be a good practice round.

I calculated the MV is 1220 fps with 320 ft.-lb. of ME. This is about 2/3 the power of my commercial 327 rounds which are rated at 1600 fps MV and 500 ft.-lb. ME. Not full power, but not a powder puff load.

I like the support Badman gave me in determining reasonable limits for the velocity this bullet would support in my application.

I've gone trough over a thousand rounds and have selected this bullread moreet for most of my .32 caliber loads. I also use their 78 grain bullet, which gets the most use in my .32 S&W (short) and .32 S&W Long ammunition. It worked well in my 327, but I was looking at emulating my 100 grain commercial load as closely and cost effectively as possible.

I did find that Badman's bullet coating was heavier and more uniform then the same coating from other coated bullet manufacturers.

Based on this bullets performance and the owners support, Badman will be my coated bullet supplier for my handgun ammunition needs (.32, .38/.357, 9mm, and ,45 ACP).

Consistent weights and quality on every single bullet! Loaded into cases with ease. Best is no smoke at the range.

Have always been pleased with the Badman products and these coated bullets are just great!

Why pay more? The 100 gr polymer coated in my 32 H&R, 327 Federal with AAA+++ results. I also use thier.45-200swc, 124&147-9mm, 200-44.mag all polymer coated with great results. Less smoke, better accuracy. Well made great bullets and that goes for thier standard lubed bullets also and don't forget the free shipping.

Nice!

The bullets I use need to be consistent in size and weight, properly formed and coated, and reasonably priced. These bullets hit the bullseye I am very satisfied with their performance.

I load the 32 100 grain coated bullets for my wife to shoot in SASS events and they work flawlessly. I use coated bullets so I don't gum up my press and to lessen the effects of handling lead. They do the job when she does.

This is my third order from Badman. The bullets I've tried have been of very high quality and very tight consistency, which allows me to make my very best ammo. Badman's pricing is better than others of similar quality, so I'm a repeat customer.